Yes; they are fastened to that crosspiece, you see; and when I pull them, it moves the rudder.
The crosspiece should now revolve with the screw as an axis.
For a neck, button a cuff around the pole between the crosspiece and head.
To get this angle, tapering blocks are fastened to the crosspiece ends, as shown.
The crosspiece at the rear is cut on the angle of the springboard.
The steel hilt and the crosspiece were thick, for a good grip.
There are three stars in the crosspiece and four in the long piece.
At last they had finished the work, and the crosspiece was drawn up, with the body.
Attach strings at A and tie to the first crosspiece of the rack.
At two corners there are upright wooden screws, some fifteen inches long with movable collars which support a crosspiece.
